Blog

Blister packer PCB field failures should be investigated from the returned assembly's original condition, not from a list of presumed manufacturing defects. Preserve the board, record the exact failed function and operating conditions, and isolate

Labeling controller PCBA traceability should connect each shipped board to its approved build configuration, material records, programming history, and release evidence. A serial number provides an identity; it does not establish those relationships by itself.

Shrink-wrap controller PCB cost can be reduced without consuming thermal margin only when the proposed construction still meets the released electrical, assembly, and installed-temperature requirements. Compare a defined baseline with a defined candidate. Ask the

77 GHz radar PCB design requires separate controls for antenna phase-center positions, guided RF feed paths, and the evidence used to accept the finished assembly. Start with the array model and the selected radar device's

REACH evidence for a PCB assembly should identify the actual articles supplied, the Candidate List substances they contain, and the product configuration the evidence covers. Where a Candidate List substance exceeds 0.1% weight by weight

RFID reader PCB antenna matching starts with the selected reader IC, the measured loop, and the intended mechanical assembly. For a 13.56 MHz ISO/IEC 14443 reader, characterize the coil, calculate the matching network for the

RoHS evidence for a PCB or PCBA must identify the materials and parts in the released build, the applicable substance limits, and any exemption being relied on. A lead-free solder process or a compliant surface

An aluminum MCPCB transfers heat through an electrically insulating dielectric before the heat reaches the metal base. Specify the dielectric material and finished thickness together, then evaluate the entire route to the heatsink and ambient.

An any-layer HDI PCB is justified when a verified routing study needs microvia access throughout the stack, and a qualified fabrication process can support the resulting interconnect structure. Often called every layer interconnect (ELIC), this

A labeling machine controller PCB should be released only after its encoder, product-detect, label-gap, and applicator interfaces have an agreed electrical and timing definition. A schematic shows connectivity; it does not prove that a short